Instructions for Cart Labelz*

Thank you for purchasing Tasdad Cart Labelz. To use these wonderful labels, simply cut out the desired label, using a pair of scissors or a sharp knife, and affix to your cartridge. These can also be used to label atomizers, bottles, or anything else you desire.

Certain sets of Cart Labelz have black letter labels. These can be used to keep associated items sorted. As an example, you could label all of your 901 batteries and battery charger as "A" and all of your 4075s as "B". Very handy!

Other sets include blank labels that you can use to label your special carts. We have discovered that pressing very hard with a ballpoint pen will yeild the best results.

Please be sure that you are not covering any atomizer holes with these products!

Instructions for E-Cig Skinz*

Thank you for purchasing Tasdad E-Cig Skinz. Due to the differences in e-cigs, especially the slight differences in seemingly similar devices, we cannot pre-cut our skins. In order to use them, you will need a sharp knife or pair of scissors, a pen or pencil, and a ruler or measuring tape.

To use E-Cig Skinz:

1. Remove your cartridge, clean and dry your device.
     Make certain that your device is completely dry.

2. Measure your device, along the length and the diameter.
     Make sure to note any atomizer holes and the places where your device
       seperates, such as between the atomizer and battery.
     If you are using scissors, it will be easier to apply your skin to one part at a
       time.
     If using a knife, it will be easier to skin your entire device at once and cut
       around the connection between parts after the skin is applied.

3. Measure, mark, and cut your skin to the proper size.
     Make sure to cut your skin a little larger than you need.
     It is easier to cut off extra than to add extra.

4. Remove backing from skin, position, and apply skin to device.
     Go slow. Make sure that there are no air bubbles, and that the skin is lined up
       perfectly.
     While applying, make sure to cut out holes where your atomizer holes are and
       around any manual switches or other areas you desire.

5. Trim off any excess skin.

6. Smooth out skin and ensure that no atomizer holes are covered up.

7. Did I mention to make sure no atomizer holes are covered?

8. Drip a little liquid on your atomizer if you need, and replace your cartridge.

9. Just to make me happy, check again to make sure your atomizer holes are not
  covered.

10. Vape away with your newly skinned e-cig.

Please be sure that you are not covering any atomizer holes with these products!

*Tasdad Design is not responsible for any damage to any device caused by the use of E-Cig Skinz or Cart Labelz. Use at your own risk.